Tele® Harness
Install
Install help and guides for your ObsidianWire Tele® harness
Tele® Harness
Will it Fit?
Layout Guide for Telecaster
Fits genuine Fender Tele
Will not fit
Squier or ‘Metric’ sized plates and knobs.
Hole Size: 9.52mm (3/8”)
Control Hole Spacing: 63mm (2.48”)
Cavity Depth: Minimum 35mm (1.38”)
Knob Size: Solid Shaft 6.35mm (1/4”) US SPEC
Switch Tip: CRL / OAK type 1.32mm x 4.78mm (.052" x .188"
Wiring Diagrams
TRADITIONAL VINTAGE PLUS FOR TELE®
Insert wires to slots as below
1 = Spare ground
2 = Spare ground
3 = Spare ground
4 = Spare Ground
5 = Output Jack Black
6 = Output Jack White
7 = Neck Ground
8 = Neck Hot
9 = Bridge Ground
10 = Bridge Hot
CUSTOM 4-WAY FOR TELE®
Insert wires to slots as below
1 = Spare ground
2 = Spare ground
3 = Spare ground
4 = Neck Cover Ground (As Below)
5 = Output Jack Black
6 = Output Jack White
7 = Neck Ground
8 = Neck Hot
9 = Bridge Ground
10 = Bridge Hot
INSTALLING YOUR NEW TELE® HARNESS
1) Find your diagram
Find the correct diagram for your Tele above.
Alternatively, you can download the full printable version for your Tele below
2) Identify your pickup wires
For most pickups:
Hot = White
Ground = Black
For different pickups you can check your pickup builders manual
3) Cut out your old harness
Cut the pickup, output and ground wires from your old harness, and remove it from your bass.
Cut as close to the old harness as possible to maintain the length of your wires.
4) Prepare your wires
Strip pickup and ground wire insulation leaving 6mm (1/4”) of bare wire.
Be Precise
Twist loose strands of wire between your fingers to create a firm tip.
5) Press & hold connector button
Use a fine screw driver to press and hold the connector button above the wire slot.
For a full guide on using the solder-less connectors, check below
6) Insert wire & release button
Insert the wire to the correct slot at a 45° angle.
Release the button and the wire should hold firmly.
Test the wire by giving it a gentle pull before moving on to the next wire.
CUSTOM 4-WAY FOR TELE®
4-Way Pickup Mod
Metal covered neck pickups used with the Custom 4-Way for Tele® mod require a second ground wire.
This separates the ground wire from the pickup coil, and the ground for the pickup cover.
Step 1) Identify the wire link between the existing ground wire, and the pickup cover.
Step 2) Cut the link
Step 3) Solder a new ground wire directly to the pickup cover.
It is easiest to do this where the old link has been removed.
